Installing Your Blocks
Installing Textured Squares
The difference between Squares and Textured Panels is just in the diffuser cover!
To set up your Textured Panels, follow the same installation steps as with Squares.
Note: Rotate your Textured Squares to change up the orientation of the 3D design.
Optional: Swapping Diffusers
If desired, you can swap the diffusers between Squares and Textured Square Panels. Look for the small notch at the corner of the panel, and using a flathead screwdriver, pull the diffuser off, and replace it with the diffuser of your choice.
Uninstalling Panels
To uninstall your Blocks Panels, remove the panel, leaving the mounting plate on the wall. Pull the tape from under the tabs very slowly so the tape stretches and does not snap. The mounting plate will release from the wall once all tape has been removed.
