Installing Your Blocks
Video tutorial for installing your Blocks
1
Installing Small Squares
- Add rigid linkers into the available linker slots as needed.
- Attach mounting tapes to the back of the panel. Ensure the round end of the tape overhangs the opening in the mounting plate. This will allow you to safely remove them later from the wall
- Remove the protective liners.
- Mount your panel by applying strong pressure for 30 seconds to each side of the panel. This will ensure the tape firmly adheres to the wall.
- Follow the same instructions when mounting the rest of your Small Square panels.
Installing Small Squares Step 1
Installing Small Squares Step 3
Installing Small Squares Step 4-1
Installing Small Squares Step 4-2
2
Uninstalling Panels
To uninstall your Blocks Panels, remove the panel, leaving the mount plate behind. Pull the tape from under the tabs very slowly so the tape stretches and does not snap. The mounting plate will release from the wall once all tape has been removed.
